How can I bypass pass theft deterrent system?
Leave the key in the ignition for 10 minutes. Turn the key to the “off” position — and leave it there for 20 seconds — after the anti-theft light stops blinking. This disables the Passlock system; it is ready to “relearn” your key.
How do I fix my passlock GM?
How to Fix Passlock for Chevy Vehicles. A temporary fix is to leave your key in the ignition, at the “auxiliary” position for about 10-15 minutes until the security light shuts off. When the light shuts off you can try to start the engine again. Rinse, repeat, and cry.
How long does it take for PASSLock to reset?
This will take approximately 10 to 15 minutes. Start the car immediately once the “Theft Sys” light stays on steadily. Remember to not turn the key off. Your car will now reset the passlock system and start as usual.
How do I reset my PASSLock GM?
How to Reset the Passlock System on GM Cars
- Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
- Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.
Where is passlock sensor located?
The Passlock sensor contains two Hall effect sensors. The security sensor is mounted under the tamper sensor.
How long does it take to reset a passkey 3?
Passkey III Reset procedure. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time. If you’re adding a new key to the system, you MUST have all the older keys with you. All previously learned keys will be erased from the system as soon as you program the first key.
What is the passkey 2 reset procedure on a Chevy?
Passkey II Reset procedure. Passkey II reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
How to do a PassLock 3 reset on a Ford F150?
How to do a Passlock III reset 1. Insert the master key with the black head into the ignition lock cylinder 2. Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 3. Wait 10 minutes or until the SECURITY light to turn off. 4. Turn the key to OFF for 5
How do I know if my key has a PassLock system?
PassLock seems to have the highest failure rate. So if you have a key WITHOUT a chip in it, chances are it’s a PassLock system. This article describes how to troublshoot and fix a PassLock system.