How do you complete a Ford drive cycle?

Idle the vehicle in Drive for 1 minute. Drive at 25 mph and drive for 15 minutes at speeds between 15-35 mph. Within this time, stop at least 5 times, and have at least 3 periods of steady speed for 90 second durations.

How long is a drive cycle Ford?

Drive in stop and go traffic conditions. Include five different constant cruise speeds, ranging from 40 to 72 Km/h (25 to 45 MPH) over a 10 minute period.

What is an OBD II drive cycle?

OBD drive cycle. The purpose of the OBD2 drive cycle is to let your car run on-board diagnostics. This, in turn, allows the readiness monitors to operate. And detect potential malfunctions of your car’s emission system. The correct drive cycle for your car can vary greatly depending on the car model and manufacturer.

How do I pass OBD II emissions?

Tips & Tricks for Passing an Emissions Test

1. Warm up your engine.
2. Make sure your car is up-to-date on routine service.
3. Fix any known engine-related problems.
4. Make sure the “Check Engine” light is off.
5. Bring your vehicle to a smog test location that retests for free.
6. Make sure the “Check Engine” light is off.

How do you know when obd2 is ready?

To check if your vehicle’s OBD II system is ready, you must do the following:

1. Turn the ignition switch to the “ON” position, but do not crank or start the engine.
2. As soon as you turn the ignition switch to the ON position, you will see the MIL (Check Engine Light) symbol come on as part of a normal bulb check.

How do I pass OBD-II emissions?

What is an OBD drive cycle and how does it work?

Drive cycles vary among manufacturers. The OBDII system sets a fault code and illuminates the check engine light if emissions exceed 1.5 times the emissions standards. The OBDII monitors are rendered not ready to monitor vehicle emissions when the power to the engine control module is disconnected.

How do I perform an OBDII driving cycle?

To perform an OBDII Driving cycle do the following: Cold Start. In order to be classified as a cold start the engine coolant temperature must be below 50°C (122°F) and within 6°C (11°F) of the ambient air temperature at startup. Do not leave the key on prior to the cold start or the heated oxygen sensor diagnostic may not run.

How does the OBD2 system work on a Honda Accord?

The OBDII system sets a fault code and illuminates the check engine light if emissions exceed 1.5 times the emissions standards. The OBDII monitors are rendered not ready to monitor vehicle emissions when the power to the engine control module is disconnected. Perform the recommended drive cycle to set the OBD II system monitors.

What is the recommended fuel tank level for the OBDII monitor?

Drive Cycle Recommendations: Most OBDII monitors will complete more readily using a “steady foot” driving style during cruise or acceleration modes. Fuel tank level should be between 1/2 and 3/4 fill with 3/4 fill being the most desirable. The Evaporative Monitor can only operate during the first 30 minutes of engine operation.