What is a code P0755?
Code P0755 refers to a “Shift Solenoid “B” Malfunction.” Most vehicles with automatic transmissions have at least three transmission shift solenoids, namely A, B, and C. Your OBD-II scanner may pick up code P0755 if your powertrain control module (PCM) detects a malfunctioning shift solenoid “B”.
How do you fix a shift solenoid B malfunction?
What Repairs Will Fix P0755?
- Changing the transmission fluid and filter.
- Replace faulty solenoid.
- Repair or replace a faulty transmission pump.
- Repair or replace defective transmission valve body.
- Perform transmission flush to clean passages.
- Cleaning corrosion from connectors.
- Repairing or replacing wiring.
How do you fix a shift malfunction?
How to Fix
- Repair or replace damages in wiring and connectors in the transmission or other related wiring harness.
- Repair or replace shorted or open transmission control harness circuits.
- Replace or refill for a new transmission fluid.
- Repair or replace transmission control wiring and shift solenoids.
How much does a shift solenoid cost?
Depending on the make and model of your vehicle, expect to pay between $15 – $100 for a single transmission shift solenoid. A pack can cost $50 to $300….Transmission Solenoid Replacement Cost – Parts & Labor.
| Type | Cost Range |
|---|---|
| Single | $15 to $100 |
| Pack | $50 to $300 |
| Labor | $120 to $400 |
| Total (Pack) | $250 to $600 |
What does shift solenoid B Electrical mean?
Shift solenoid B allows the transmission to shift between second and third gear. If the PCM records code P0758, it indicates that the PCM cannot see the proper change in engine RPMs or the correct increase in road speed that should be happening during a shift from second to third gear.
Can a shift solenoid be cleaned?
A transmission solenoid valve controls the flow of transmission fluid through the transmission of a vehicle. Fix this issue by cleaning the transmission solenoid valves, but only attempt this job if you have basic mechanical knowledge and are familiar with your vehicle’s transmission.
What does the OBD2 code p0755 Hyundai mean?
OBD2 Code P0755 Hyundai definition: Shift solenoid valve B is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (ECM) (throttle opening). Gears will then be shifted to the optimum position.
What does the p0755 code mean on a Toyota Corolla?
All our repairs are backed by our 12-month / 12,000-mile warranty. The P0755 code indicates that the transmission’s shift solenoid B has experienced a malfunction, and the computer has detected it. The P0755 code indicates that there is a problem with the transmission’s shift solenoid B. Note that this only applies to automatic transmissions.
How do you fix a p0755 Shift Solenoid code?
The most common repair for the P0755 code is replacement of the shift solenoid circuit. However, other repairs may include: It is important that mechanics take all appropriate diagnostic steps when dealing with a P0755 code. Assuming that the code indicates the shift solenoid itself is at fault is the wrong way to proceed.
What does the p0755 code on a gear ratio mean?
If the P0755 code is set, it means that the computer has detected that the actual gear ratio used is different from the gear ratio calculations based on input from engine speed, throttle position and other aspects. Note that some vehicles may require more than one erroneous operation for the code to be stored. What causes the P0755 code?