How do I connect to CC3D?

Make sure your CC3D flight controller is not connected to the PC or the battery and click the ‘Next’ button. Click the ‘Erase all settings’ checkbox and click the ‘Upgrade’ button. The progress bar should become active and you will need to connect your CC3D to the PC via the USB cable as instructed.

Does CC3D have GPS?

CC3D or Atom flight controllers do not support GPS functions such as Return to base or Position Hold. The original CopterControl (CC) board does not have memory left for GPS use. The only purpose for GPS use is telemetry using radio modems (OPLink) or GPS position send to OSD device.

What is CC3D?

CC3D is a flight controller that is developed by OpenPilot project, it stands for CopterControl 3D. Currently supporting two platforms, the CC3D and the Revolution (Revo). If you have heard about Naze32, the CC3D is kind of like the father of Naze32, both use 32-bit processors, and they are the same size.

Can ArduPilot run on Arduino?

ArduPilot is a fully programmable autopilot that requires a GPS module and infrared X, Y and Z rangefinders to create a functioning Unmanned Aerial Vehicle (UAV). Firmware is already loaded, but the autopilot software must be downloaded and loaded onto the board by the user. It can be programmed with the Arduino IDE.

How do I set up a vehicle in CC3D?

Press the green ‘Vehicle Setup Wizard’ button and you a pop-up will appear. Make sure your CC3D flight controller is not connected to the PC or the battery and click the ‘Next’ button.

How do I upgrade my CC3D to GCS?

Click the ‘Erase all settings’ checkbox and click the ‘Upgrade’ button. The progress bar should become active and you will need to connect your CC3D to the PC via the USB cable as instructed. Click the ‘Next’ button once GCS has finished updating your CC3D. Click ‘Next’ on the OpenPilot Board Identification window.

How do I upgrade my CC3D flight controller?

Press the green ‘Vehicle Setup Wizard’ button and you a pop-up will appear. Make sure your CC3D flight controller is not connected to the PC or the battery and click the ‘Next’ button. Click the ‘Erase all settings’ checkbox and click the ‘Upgrade’ button.

How do I configure CC3D to work with uart1?

CC3D works only with minimal messages. (POSLLH, DOP, SOL, VELNED) Open Configuration View window: View > Configuration View . Move to PRT (Ports) in left column. Change message output in UART1: only UBX for protocol in/out. Change baudrate for UART1 port, same baudrate set for Flexi/Main GPS port.