How long is Auckland Harbour Bridge?

Auckland Harbour Bridge/Total length

The bridge is 1,020 metres (m) long and has 7 spans. Each span is identified by a letter, A at the north end to G at the south end. The navigation span, B, is 243.8 m with a 43.3 m clearance at high water. There are in fact two bridges, A to C 597.4 m long and D to F 422.2 m long.

How deep is the water under the Harbour Bridge Auckland?

This article’s tone or style may not reflect the encyclopedic tone used on Wikipedia.

Auckland Harbour Bridge
Clearance below 43.27 metres (142.0 ft) at high tide
Designer Freeman Fox & Partners
Constructed by Dorman Long and Cleveland Bridge & Engineering Company

How high is the top of Auckland Harbour Bridge?

Constructed of structural steel and reinforced concrete, the bridge spans 1.2 kilometres across the Waitemata Harbour. The bridge reaches 64 metres above the water at its highest point, the top of the arch.

Can you cycle over Auckland Harbour Bridge?

A lane on Auckland Harbour Bridge could temporarily be closed to cars, so cyclists and pedestrians can use it.

Can you walk on Harbour Bridge?

Walk Across Sydney Harbour Bridge. Like San Francisco’s Golden Gate Bridge, the walk over Sydney Harbour Bridge can only be accessed from one side (the other is reserved for cyclists). Luckily, walkers have the eastern side with the most iconic views, including the Opera House, The Rocks and Fort Denison.

Who owns the Harbour Bridge?

Government of New South Wales

Sydney Harbour Bridge
Owner Government of New South Wales
Maintained by Transport for NSW
Preceded by Gladesville Bridge

Is there a body in the Harbour Bridge?

More than 1,000 labourers worked on the project, including 180 sent out from the UK. 4 men fell to their deaths during the bridge’s construction. There is a memorial to them on the North Shore.

Who built Harbour Bridge?

Under the direction of John Bradfield of the New South Wales Department of Public Works, the bridge was designed and built by British firm Dorman Long of Middlesbrough (who based the design on their 1928 Tyne Bridge in Newcastle upon Tyne) and opened in 1932.

Can you ride a bike over the Harbour bridge?

Yes, you can bike over the Sydney Harbour Bridge, but you must ride within the dedicated cycleway. Cyclists are not permitted to ride on any other part of the Sydney Harbour Bridge.

How long does it take to climb the Harbour Bridge?

approximately 2 hours
How long does it take to reach the top of the Bridge from the time of check-in? It takes approximately 2 hours to reach the Summit. This includes time to suit-up and complete your pre-climb safety preparation. The descent takes about an hour.

How long does it take to walk the Harbour Bridge?

You can walk across the bridge from either direction, and it takes between 15-30 minutes, depending on the pace you set.

How many lanes does the Auckland Harbour Bridge have?

The Auckland Harbour Bridge is an eight-lane motorway bridge over the Waitematā Harbour in Auckland, New Zealand. It joins St Marys Bay on the Auckland city side with Northcote on the North Shore side. It is part of State Highway 1 and the Auckland Northern Motorway. The bridge is operated by the NZ Transport Agency (NZTA).

Why is the Auckland Harbour Bridge so important?

Standing sentinel across the Waitemata Harbour, the Auckland Harbour Bridge is a crucial piece of infrastructure. It connects the metropolis of the central business district to the North Shore and beyond to Northland.

How much does it cost to cross the Auckland Harbour Bridge?

^ Dearnaley, Mathew (5 July 2011). “$6 toll to cross Auckland Harbour Bridge”. The New Zealand Herald. Retrieved 26 July 2013. ^ Bridging the Gap, Slide 15, North Shore City Libraries. Retrieved 8 June 2008. ^ ” Michael Lee: Sins of the fathers – legacy of harbour bridge”. The New Zealand Herald. 1 June 2009. Retrieved 17 September 2011.

Why is there no cycle path on Auckland Harbour Bridge?

Auckland Harbour Bridge seen from above. When the bridge was built, rail lines and walking and cycling paths were dropped for cost reasons, and neither were they included during the clip-on construction (people can walk on the span only via guided tours). In 2007 discussions about the addition of a cycle and footpath link was mooted.